2024 AGI Enclosed Belt Conveyor 22

2024 AGI Enclosed Belt Conveyor 22

Available in belt widths from 18" to 54", this is our original model. The unique bell-shaped carrying idler provides the trough for the belt and utilizes two external bearings as opposed to the six internal bearings associated with a conventional idler. The bell-shaped idler also has built-in self aligning characteristics for both single and bi-directional conveyors.

As with all Hi Roller® conveyors, the Hi Roller is custom designed and built to your specific requirements. Hi Roller will assist you to determine the best combination of performance and cost to provide you with the safest, most cost effective solution to suit your needs today and in the future.

The AGI Hi Roller Conveyor incorporates a unique spool shaped idler to provide a troughed support for the conveyor belt. The spool shaped idler utilizes two external bearings as opposed to six internal bearings on more conventional idlers.

The idler is constructed with a heavy wall pipe that passes through the center of the idler. This provides rigid support. The center pipe is then reamed to just the right tolerance to accept the turned and polished stub shaft that passes through the external bearings.

This design is superior to a single continuous shaft for obvious reasons. First, installation clearances do not always permit the removal of a single continuous shaft. Second, more generous tolerances are needed to pass a continuous shaft through the complete idler. This permits shaft deflection through the idler and bearing. Third, over a period of time a continuous shaft is more apt to become seized to the internal idler which would require cutting the shaft for idler removal.

The stub shaft and bearing are supplied by Hi Roller as an assembly to assure that the shaft cannot rotate independently of the bearing and that the shaft cannot move in or out within the bearing. The bearing itself is easily adjustable for belt tracking.

Features may include:

Standard of the industry

Will outwear and outlast competing conveyors and takes less maintenance than competitive models

Gradual Inclines and Sharp Upbends

Intermediate Discharge Trippers

Reloading in Both Directions

Worm Gear Reduction Manual Belt Tensioners

Contains dust and spilled materials which automatically reload back onto the belt

Idler bearings are mounted externally. Idlers are easily adjustable for belt alignment

Bottom lined with Antistatic UHMW plastic

Unique fastening system allows the UHMW Bottom Liner to remain flat even though it may expand or contract due to variations in temperature

Easily removable covers and side-mounted inspection doors for inspection and maintenance